Simply Automated UPP Betriebsanweisung Seite 2

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 1
Getting Started
DKIT-04 Dimmer Starter Kit
Simply Automated, Incorporated
Simply Automated Pre-Configured SimplySmart
TM
Series
Simple-n-easy, ready to use lighting control. No computer programming required!
Utilizes SimplySmart
TM
technology to make installation a breeze.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic safety precautions should always be followed, including the following:
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2. Installation should be performed by a qualified electrician.
3. Keep away from water. If product comes into contact with water or other liquid, disconnect immediately.
4. Never use products that have been dropped or damaged.
5. Do not use this product outdoors.
6. Do not use this product for other than its intended use.
7. Do not connect multiple lamps that, when combined, exceed the maximum load rating of the product, de-rated for
multi-gang boxes.
8. Do not install in areas that can exceed 120°F (e.g., in an attic).
9. To avoid the risk of overheating and possible damage to other equipment, do not use this product to control a
receptacle.
10. Do not cover the product with any material when in use.
11. SAVE THESE INSTRUCTIONS.
DKIT-04 Security Panel Dimmer Starter Kit
Easily Connect Simply Automated Lighting to Any Alarm Panel with Low Voltage or Contact
Output Capability. Includes 2 Standard Dimmers and 1 I/O Module with 3 inputs/2 outputs.
Getting Started
Section 1: Very Important Pre-Installation Notes
The security panel will need one or more low voltage or contact closure outputs to
interface with the I/O Module.
Simply Automated dimmers require both a neutral (white) and hot (black) connection.
Do not use on a 3-way circuit (intended for installation on a circuit controlled by one
switch/dimmer).
Your home should be no more than 2500 square feet and have only one breaker panel.
A phase coupler is required in some home installations. See Section 5 for more
information.
Not intended for use in multi-dwelling (condo, apartment, duplex) units.
6108 Avenida Encinas, Suite B, Carlsbad, CA 92011 USA
Technical Support: www.simply-automated.com
or 800-630-9234
452-00004-1001 Rev. B Revised: July 7, 2009
Seitenansicht 1
1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare